Recommendation Related to Cutting
|
Before cutting by means of Adler saws, you should take care some criteria. Thanks to these criteria, both your cutting process will be at desired level and you shall decrease the costs by increasing the life of the set.
|
|
|
 |
|
Chip is burn, slight curved and wide in this situation,
increase cutting speed and/or proceeding
|
 |
|
Chip is exfoliated as dust. It’s color is normal.
In this situation, you shall increase the proceeding.
|
 |
|
Chips curved as picture and color is normal. This shows your cutting speed and proceeding value as correct.
|
|
|
Before opening saw and mounting it on the machine, you should wear certainly safety glass and gloves.
Do not never open the saw purchased by clashing or dropping.
After installing it on the machine, take off the coating over tooth.
After installing it on the machine, you should stretch the saw with recommended values.
After installing the saw, on the first cutting, you should use as 50% of recommended proceeding value.
You can find the cutting speed values, appropriate for the material to be cut on the below table. You shall maximum set life and minimum cost on the condition of following cutting speed and coolant emulation values given on below tables.
As per formation the chip left during cutting process, you can increase or decrease cutting speed given on the table.
If there is various vibrations and abnormal, stop the machine and check the tooth
If there is no problem with tooth, accordingly you can increase or decrease cutting speed.
At the end of the work or if the saw would not used for a long time, you should leave the saw loose.
|
